MX-3.com

i took a look at the arams and the bootom arm is moving on the back conection not the front so what is it that i broke then

mccabe wrote:and when my cars parked i can move my trie back and forth and it makes a clicking sound???? any help or ideas would be great

Check your wheel bearing and tie rods/a-arm bushings.

Usually if you can jack the car up and move the tire back and forth your wheel bearing is shot

i lookoed and i pretty sure its not the wheel bearing due to it was frine before and i think they have been replace but your probly right about the trie rod i had my car up on jackes yeterday putting my all sesons on that i got for 45 bucks on alloy rims and they spun fine no noise but the noice came when i moved thetire back and forth

well, of course it was fine before you hit the curb . make sure theres no play in that tie rod end, and if there isn't. Chances are its your wheel bearing.

mccabe wrote:when my cars parked i can move my trie back and forth

wait, you can move your tire back and forth, while the car's parked? Like a inch or two forward and backwards? Without moving the car? Like, independantly from the whole car, the tire moves back and forth?

Erm... my rim did that too, independantly from the car, while parked, you could rock the tire back and forth a good bit.
You know what the problem was?



Yes, my control arm (or a arm) was ripped in half there. Not a smart idea to drive on, but heck, I never claimed to be smart.

super k was right i took my a arm off and it was broken too(i drove on it too )