MX-3.com

around edmonton area, just need a part from the inside, can pick up

I will have one in the future, but not right away. How badly do you need it? I am looking to get my spare rebuilt so I can swap it into my daily driver. That one will be garbage when it's out. If you can wait a while, you can have it.

thank you, that would be great. how long are you thinking? i was putting in my new quaiffe and i found a broken clip and spring sitting in the bottom of the case when i opened the case up. i am going to be doing a little engine touch up work before i put it all back together, but i cant have my car sitting in peices for too long where it sits. mabey a couple weeks at the most

I'm not exactly sure. My clutch is junk and the previous owner welded the drain plug because it was leaking...nice. So I would like to do it soon. But with other projects on the go and life and stuff...I can't see it getting done until after Christmas.

I'll let you know when I get it done and we'll see if you still need anything.

I have one sitting in my garage waiting to go back to the pick-n-pull. What do you need exactly? If it's easy enough, I can pull it out before returning the unit. I'm in Red Deer.

it is a little bronze coloured clip with a hook on either end, maybe 2 inches long. there was also a spring that was sitting in the bottom of the case, it is still good, problem is i cant see exactly how they go, or where. might be other little clips that went together as an assembly that i dont know but i doubt it. let me know if you know what i am talking about.

Sorry, I don't. I'm going to the pick-n-pull today and will returning the tranny, but if I get a chance I will try to open it up and see if I can find what it is you need.

Also, to clarify, my G-series is from a 4 banger while bshop's is from a v6. The internals are supposed to be the same however.

can antone else help me out?