Page 1 of 1
V6 Badge Removal
Posted: November 17th, 2007, 12:50 am
by bloodred
Apologies, if this is a dumb question, but how does one remove the rear hatch V6 badge? is it just double-sided-foam-taped on? or is there clips in behind there somewhere?
cheers
Posted: November 17th, 2007, 4:16 am
by OutlaW
no clips, just glue ...
Posted: November 17th, 2007, 5:33 am
by umcamara
You'll also wanna have a can of WD-40 or some kind of residue remover. Some of the badges can leave a real hard residue that takes some work to get off.
Posted: November 17th, 2007, 6:27 pm
by rekognize
Use a plastic ruler together with WD-40 and scrape away
Posted: November 17th, 2007, 9:10 pm
by Kirk95gs
yeah its double sided tape..... wd-40 will work, any type of solvent.. but remember when installing use a good quality tape.. 3m or something.. and make sure you clean the surface .. use rubbing alcohol and then tape.
Posted: November 17th, 2007, 9:44 pm
by umcamara
Kirk95gs wrote:yeah its double sided tape..... wd-40 will work, any type of solvent.. but remember when installing use a good quality tape.. 3m or something.. and make sure you clean the surface .. use rubbing alcohol and then tape.
Or better yet, IMHO, leave them off for a nice CLEAN look.
Posted: November 17th, 2007, 10:20 pm
by bloodred
that was the plan.
thanks everyone.