Page 1 of 1
map sensor help!!!
Posted: January 17th, 2007, 4:01 pm
by delpy32
1992 mx3 1.6 5 speed...will a map sensor work from anything else...there are no junkyards around here that have any mx3's so...and im not spending like $250 for a new one...is there any other cars that i can get one out of..?
thanks-Ryan
Posted: January 17th, 2007, 4:27 pm
by ariesdude
Posted: January 17th, 2007, 6:44 pm
by monty73741
OR car-parts.com
I saw a post on a miata site about a maf-map conversion pretty interesting
Posted: January 19th, 2007, 5:12 pm
by delpy32
i got told it was a map sensor...
its a lillte box about the size of a wedding ring case...and it is mounted on the firewall directly behind the throttle body...it has 2 hoses...one goes to the throttle body and the other comes from a coffee can looking thing on the left side of the motor...then there is a few wires that plug into the right side of this sensor...
i was told that this "map sensor" controls the fuel/air ratio...
someone please help me figure out what this thing is...
thanks-ryan
Posted: January 19th, 2007, 5:38 pm
by cjthor
delpy32 wrote:i got told it was a map sensor...
its a lillte box about the size of a wedding ring case...and it is mounted on the firewall directly behind the throttle body...it has 2 hoses...one goes to the throttle body and the other comes from a coffee can looking thing on the left side of the motor...then there is a few wires that plug into the right side of this sensor...
i was told that this "map sensor" controls the fuel/air ratio...
someone please help me figure out what this thing is...
thanks-ryan
nope that is the evap canister purge soleniod i think....check with your dealer. Definitely not a map sensor.
Posted: January 19th, 2007, 5:41 pm
by delpy32
i dont have any dealers around here amd when i call out of town thaty dont know what im talking about...
Posted: January 19th, 2007, 6:27 pm
by ariesdude
Yes it is called (canister) purge solenoid valve - your best bet would be the dealer or get an used on from a member here or on ebay.
This is an EGR solenoid on ebay -
http://cgi.ebay.com/ebaymotors/MAZDA-PR ... 3741QQrdZ1
I dont remember if it looks the same as the purge solenoid - the only difference (if there are any) would be the electrical connector. So it can be made to fit with some wire splicing (if the connector doesnt fit).
Posted: January 19th, 2007, 6:30 pm
by delpy32
ok...
it doesnt look like that one...its much different...but ill call my local parts store and see if that can get it in...
thanks
Posted: January 19th, 2007, 6:37 pm
by delpy32
mine is cracked and one of the nipples is broke off...it is for the hose that goes to the canister...so the one hoses isnt hooked up...can i take it off and just connect the hose from the canister to the hose o the throttle body just for now...or just leave it like that until i get a new one???