distributor change cost
Posted: September 2nd, 2006, 12:28 pm
how much would you pay to have disty changed on k8?
MX-3.com
The Worlds First and Largest Mazda MX-3 Forums
http://mx-3.com/phpbb3/
distributor change cost
Page 1 of 1
Posted: September 2nd, 2006, 2:08 pm
free... well to have it changed it takes like 3 - 5 minutes. Take cap and rotor off (note the position) take 2 bolts off.. pull... get new disty and insert in same position. Install new rotor (make sure its same size either big or small for new disty) Install cap and walla.. you dont even need to take off the cables.. unless u nget a new cap. Honestly you are giving your money away if you are paying someone to do it..
Posted: September 2nd, 2006, 10:14 pm
Agreed, the disty itself is usually around 3-400. The work is minimal at best.
Posted: September 5th, 2006, 12:38 am
Ditto on the Disty.
I just changed mine the other week.
Pretty simple install.
Just dont drop the bolts.
If you have to have someone else do it...
Shouldnt be more than a cost of a Value meal to do it.
I just changed mine the other week.
Pretty simple install.
Just dont drop the bolts.
If you have to have someone else do it...
Shouldnt be more than a cost of a Value meal to do it.