MX-3.com

ok i have an automatic tranny with a b6ze DOHC engine(4 cyl) in my car now... i want to change the tranny to a 5-speed...and i was wondering if a 5-speed tranny for a SOHC engine will fit on my DOHC engine?...i need expert advice

i just put a 93 5 speed in a 94 auto,,,plug and play.even electric speedo goes rite in ,shafts fit also,the only difference was the pedal assembly was slightly different so if you get the pedals from a 94 or newer its a bolt up..93 pedals had to be altered

ok well thank for that info but i still need 2 know if a 5-speed tranny from a SOHC will fit on my DOHC???

jimishadow wrote:i just put a 93 5 speed in a 94 auto,,,plug and play.even electric speedo goes rite in ,shafts fit also,the only difference was the pedal assembly was slightly different so if you get the pedals from a 94 or newer its a bolt up..93 pedals had to be altered

A 1993 is a SOHC

A 1994 is a DOHC


He said he's done the swap you are asking about and it IS a direct bolt up.

it will fit

HAHAHA...my bad i thought he said he put a 95 in his 94...aiight well thanks for the info and now i will go and get my tranny .. o0o by the way what were the minor things you had 2 adjust on your clutch pedal?

i cut the clutch pedal off the assembly and drilled a hole,you will see where to drill it on top,yhere is a hole already threaded on car you need to drill one on the cluch assembly,,if you dont support it from top it will eventually crack the firewall where clutch master bolts through,try to get pedals from a 94 and up and its bolt in.

Can I take a 5-speed tranny from a RS 4 cylinder DOHC and bolt it up to a 1.8 DOHC v-6 ? So basically, A RS tranny to a GS engine ?

No.

Damn oh well, I guess I have a whole RS car to part out then.