MX-3.com

In the event that my car does not sell, I will be taking it off the road and rebiulding it. COMPLETELY!

I will be looking for such items as the following...

Turbo 4 cyl, or Supercharged 6 engine for motor swap
Any place/person locally that could help me with doing this swap
Lambo door hinges(I know I can get the ones from ebay, but I want the ones that flip up 90 degrees, not 65)
A wing that is low and long, similar to a porche Turbo 911
place for replacement carpet(mine has a couple small rips)
Affordable 19" wheels and tires


There are a few more things that I am going to be doing, But I want to surprize a few people


I figure this will be a non-stop, 2 year project so any help in the future would be greatly apprieciated

Thanks,


Will

the BP swap will leave tons of room to put in big intercooler, turbo and the rest. I imagine they are cheaper to pick up then a KLZE, cheaper to install, and adding turbos is simpler. Also capable of more than enough power to keep you happy.

What wrote:the BP swap will leave tons of room to put in big intercooler, turbo and the rest. I imagine they are cheaper to pick up then a KLZE, cheaper to install, and adding turbos is simpler. Also capable of more than enough power to keep you happy.

Well that probably depends on what you are more familiar with. I think the KLZE is quite simple to swap but at the same token, I think you have way more potential with the BP swap as far as forced induction. The KLZE is a pain to turbo or supercharge mainly due to high compression and lack of room available. I think if I were to start over with another MX-3, I would try a Turbo 4 cyl.

Now all you have to do is get some local BC guys to help you out and give you input on where to go

BP all the way.