$100 for all of the following... must take all, and soon.
the block I sandblasted and cleaned up the otherwise hot rusty cast iron look. The rods with pistons attached are out.. I was going to put new rings on and put it back together as is. Doesn't look like excessive cylinder wear and the engine ran before I yanked it. The tops of hte pistons have also been cleaned up and are ready to go.
I have a spare BP head that is stock. I picked it up to do a flow test comparison of the BP head I modified. The modified head is gone, now this stuff needs to be. Chambers and ports were lightly sandblasted... I never did do a flow test on them.
Box of other miscellanious BP parts... like intake manifold and such.
Must take all and pick up as mentioned. Shipping takes too much time.