MX-3.com

Posted: **March 7th, 2005, 12:42 pm**

where can i get z3 fenders? thanks

Posted: **March 7th, 2005, 1:49 pm**

ebay

Posted: **March 7th, 2005, 1:53 pm**

http://www.psituning.ca
http://www.gforcecustomizing.com

or just buy universal inserts

Posted: **March 7th, 2005, 2:35 pm**

Or you could get fancy and fab some up your self like me!!!

Posted: **March 7th, 2005, 6:45 pm**

some one told me pakfeifer

Posted: **March 7th, 2005, 7:35 pm**

Hey how did you fab em? Just cut and bend or what? they look good...and what did you used to cut em if you did

Posted: **March 7th, 2005, 10:28 pm**

MarkMoore wrote:some one told me pakfeifer

well pakfeifer sells the one from gforce and so does psituning. Don't try to deal directyly with gforce as the are very hard to reach. Bad communication too.

Posted: **March 8th, 2005, 10:34 am**

Yeah I used a dremel too with a cut off disc to cut them....used wide mouth vice grips to bend the vents...and fiberglassed the lip and in between the flaps!!!

Posted: **March 8th, 2005, 11:24 am**

Thats awsome buddy...I was acculy thinking about it the other day before I saw urs, seems dumb to spend hundreds on a new fender when you can cut ur own. When you say fiberglassing between the flaps, is that like, Putting fiberglass in the holes or what? I'm kinda confused...

Posted: **March 8th, 2005, 1:20 pm**

its to finish the flap at the top and bottom...i did to make it look better, so it didnt look like i just cut the flaps and and twisted them in gives it the true vent effect!!

Yeah and i havent seen any other fender(for mx-3) look like mine!!! Mine has a lip around the vents, not just the vents flat on the fenders!!

for sure i think it cost me around $30-$40 to make..so yeah saved money and got something no one else has!!!