Page 1 of 1
KLZE running... won't go into gear while running.
Posted: November 12th, 2004, 6:37 pm
by Tryk
Ok got the KLZE running nice. While the engine is off the car seems to go into gear nicely, but once running, the car will not go into gear. I have bled the clutch a few times trying to get it to work but can't seem to do it.
It is a brand new ACT street kit for a MX6 that was installed. The release bearing did look a little different, but thought it would be fine. Please if you have encountered anything like this or have any suggestions let me know.
Re: KLZE running... won't go into gear while running.
Posted: November 13th, 2004, 4:43 am
by IanL
It sounds like the clutch is not releasing. Some people have fixed this by making and fitting a longer operating rod.
Re: KLZE running... won't go into gear while running.
Posted: November 13th, 2004, 10:25 am
by babyblueMX3
yeah Ian is right..It was the same thing for me..search for act in the v6 forum...
2 things help for me..welding washers to the rod so it is longer and pushed further...and the other thing is get a stainless steel clutch line..
it should work..it has for everybody else
Re: KLZE running... won't go into gear while running.
Posted: November 13th, 2004, 5:56 pm
by Tryk
Thanks guys! I got the clutch working by just adjusting the pedal. It is pretty much maxxed out right now so yes it might be a good idea in the future to extend that rod.
Thank god I didn't have to drop the tranny!
Re: KLZE running... won't go into gear while running.
Posted: November 14th, 2004, 4:42 pm
by C-MX-DA3
i have the same problem with my clutch, i should try to adjust my pedal clutch too.is this a a constant problem wth people who have klze and act clutch?