Page 1 of 1
KLZE STATS
Posted: May 28th, 2004, 3:50 pm
by alibath
i know i have asked this before but i only got 1 replay. So here goes. Can every one who has the KLZE engine in there mx-3 tell me what stats they have i.e 0-60.1/4mile. BHP(dyno,ed)top speed
Re: KLZE STATS
Posted: May 28th, 2004, 5:03 pm
by TsiMiata
I got a 14.7 1/4 mile. Car is running a bit lean and vris points aren't right. top speed is 113mph since the jspec ecu limits it. You can bypass it, I just haven't.
Re: KLZE STATS
Posted: May 28th, 2004, 10:16 pm
by babyblueMX3
did a 14.8 without vris number 2 working on crappy tires..Oh it was my first time.. I'm going again tomorrow I'll post you my new times
Re: KLZE STATS
Posted: May 29th, 2004, 8:23 am
by odds1
Originally posted by babyblueMX3:
did a 14.8 without vris number 2 working on crappy tires..Oh it was my first time.. I'm going again tomorrow I'll post you my new times
If you are Turboed vouldn't you disengage the
vris? I would really think you could have done a lot better with a turboed ZE.
But I don't have one so I don't know.
Odds
Re: KLZE STATS
Posted: May 29th, 2004, 9:34 am
by babyblueMX3
lol..that's because the turbo isn't in yet..it's a project I have..Now I have ze with UR pulley, 13pound FW, 67mm TB, 2.25" cat-back, pheno spacers, hi-flow cat....pretty much it
Re: KLZE STATS
Posted: May 31st, 2004, 2:14 am
by PATDIESEL
My top speed is about 135. But the stock speedo isn't going to be correct at that speed. Tranny limited (redline in 5th gear), and hauled *** all the way to 135MPH. Racing a RSX Type S. ZE and a 1.8L tranny.
Re: KLZE STATS
Posted: June 1st, 2004, 12:12 am
by Jeff_Jeske
Well you should be able to yank 13s with sticky tires...what are your cars weighing in at?
The PGT race weight of 2600LBS is pulling consistant 14.1s at 98 with a 2.0 short time.
I am curious what the best MX3 ZE run is because I am hunting for an MX3 with the swap.