Page 1 of 1
Can i ....(b6t question)
Posted: January 28th, 2004, 2:19 pm
by nos92mx3
Im aquiring a 88 323 gt with engine ecu etc... can i just swap the harness's so i can use the b6t computer. I just lost my job with enough money to buy the car and i have plenty of time so time is not a problem, what kind of problems will i run into?
Re: Can i ....(b6t question)
Posted: January 29th, 2004, 8:25 pm
by nos92mx3
Help? Another question can i use the 323 ecu with my 92 sohc harness?
Re: Can i ....(b6t question)
Posted: January 29th, 2004, 10:07 pm
by maldo
Read my faq in my signature. You can't easily use the GTX ecu or harness. Get a Protege LX ecu and plug it into your existing harness, use that harness to run your B6T.
Re: Can i ....(b6t question)
Posted: January 29th, 2004, 11:41 pm
by Shady469
the main thing that is holding you back is the distributor. the 323's use a vac. advance unit that it not compatible with our ECU.
i agree with maldo use the pro lx ecu or just the sohc mx ecu for the time being. thats what ive been using. the swap is fairly easy, and i wish you the best of luck.
http://www.geocities.com/explosivemazda/pageone.html this should help some
<small>[ January 29, 2004, 10:41 PM: Message edited by: Shady469 ]</small>
Re: Can i ....(b6t question)
Posted: January 30th, 2004, 1:12 pm
by nos92mx3
Is there any way that i can just swap over everything from the 323 to my mx3? I will have the entire 323.? OR is this a road yet traveled?