MX-3.com

I was just wondering if anyone had the blueprints or knows where to get them for the 1.6 sohc mx3?
This would be a great help i just dont want to go at it with a dy grinder and screw something up.

Thanks

blue prints? Port the head until the ports are a little(just barely) bigger than the stock gasket, then enlarge the gasket to accommodate. Then i'd suggest having a machine shop do a valve job.
Personally i velocity stack everything i do...Big on the out side and gradually smaller as you move in.
just my 2c
but if you dont feel comfortable doing it get it done by some one who has before. and BTW i've got a stock SOHC head and an I/M that i ported if you want them...(for free)

<small>[ December 03, 2003, 09:35 AM: Message edited by: Shady469 ]</small>

Hey shady...i may be interested in the stock 1.6l head and ported IM, if you haven't already sold them or got rid of them. Im in southern PA right now, maybe if your close i can pick up. Ok, ill shoot you an email soon
(not trying to jack your thread nos92, but i dont know where to get the "blue prints")
later all,

If i could get those off of you that would be phenominal . one problem im live in ny and i think you live in Va.If you could find out the shipping charges To Farmington Ny zip 14425 it would be greatly appreciated. Id pay for the shipping and give you some money for your troubles of shipping them. Thanks alot.

Hey, if everyone falls through I to am intersted in the heads. I would be willing to pay for shipping and then some.