swap update
Posted: March 22nd, 2003, 1:24 pm
yeah this has sucked so far. turns out you need to switch over the ENTIRE passenger side bracket and mount. and it was a pain to get the mount off of the B6T. and that trany flange needs to be grounded ALOT, like 1 inch. Wiring hasnt been to bad. the RX-7 fuel pump went right in(used same harness). for the bacv i had to get rid of all the plastic on the clip and just plug in the wires (using the stock ends) to the terminal on the B6T BACV.
still can't figure out why the damned tranny won't take fluids but im gettin the guy whos doin the I/C pipes to fix it.
remember your firing order!!! this has hampered everything but hopefully maldo will relate his findings.
another tid bit: i HIGHLY recommend the polyurethane filler (used on car windshields) to fill the mounts. the motor does not move now. at all.
ive been taking pics along the way and ill post them when its done.
still can't figure out why the damned tranny won't take fluids but im gettin the guy whos doin the I/C pipes to fix it.
remember your firing order!!! this has hampered everything but hopefully maldo will relate his findings.
another tid bit: i HIGHLY recommend the polyurethane filler (used on car windshields) to fill the mounts. the motor does not move now. at all.
ive been taking pics along the way and ill post them when its done.