Page 1 of 1
Short shift problem
Posted: February 28th, 2002, 5:53 pm
by Brainless
Hey I just installed a custom short shift on my mx-3 and I have a little problem. On neutral, if I push the stick right or left, it stays there instead of getting back to the middle. I was told by a few people to loose the bolt the holds the bushings, so that what I did, but it didn't work (and the stick became all loose and not precise). Do you have any idea?
Re: Short shift problem
Posted: February 28th, 2002, 11:48 pm
by white fish
hey I forgot to mention you need to greese the ball with white litheim greese<P>try that
Re: Short shift problem
Posted: March 1st, 2002, 8:57 am
by Brainless
I used bearing greese, is that ok?
Re: Short shift problem
Posted: March 2nd, 2002, 12:51 am
by white fish
I think thats too sticky
Re: Short shift problem
Posted: March 2nd, 2002, 10:18 am
by Brainless
Well then I'll try white grease this week.<BR>Thanks!
Re: Short shift problem
Posted: March 2nd, 2002, 12:02 pm
by mrspanky79
Brainless did you make the shifter your self? and how did it turn out. Did you fallow my instruction?
Re: Short shift problem
Posted: March 2nd, 2002, 3:12 pm
by justin h
What was the link to the instructions again. I might be doing this soon. Thanks.
Re: Short shift problem
Posted: March 2nd, 2002, 6:59 pm
by Brainless
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by mrspanky79:<BR><STRONG>Brainless did you make the shifter your self? and how did it turn out. Did you fallow my instruction?</STRONG><HR></BLOCKQUOTE><P>Nope, Whitefish did it.