MX-3.com

225/50 on an 8J will look like this, looks massive to me lol



I thought 16x8 grids where only available in ET10 or 20? If so I would go 20 and hope you don't throw mexipoke

available in +20. So you're saying they'll fit?

I was going to go do some measurements later...

Yea I would measure as I think you will have tread outside the arch.

Low offset wide rims need at least some stretch...

youdirtyfox wrote:225/50 on an 8J will look like this, looks massive to me lol



I thought 16x8 grids where only available in ET10 or 20? If so I would go 20 and hope you don't throw mexipoke

Perty

Did the math, I need 1/2" more height clearance in the wheel well from stock

And 0.79" (20mm) total width clearance. This doesn't seem like a lot, so I'm thinking it should fit.

Just need to measure where stock wheel exists in the well, and determine what offset to get.

I have access to a fender roller and I'm not afraid to take a sledge to the spring mount.

Too bad it snowed today.

Also speedo should read 4% slow. (100 on the clock is 104 on the gun)