parts for sale all from an escort Gt
USED
BP motor (bought with 95000kms)
ported and polished
tranny (100000kms)
5" monster auotmeter tach
air/fuel gauge
EVERYTHING ELSE STILL IN BOXES
center force dual friction clutch
clutch masters 10lb flywheel
all driveahfts and half shaft
pilot and throwout bearing
Ecu
header
new belts/plugs/wires etc
all motor and tranny mounts
everything $2000
email me at maxed_mx3@hotmail.com
Parts For Sale!
-
- Regular Member
- Posts: 66
- Joined: November 5th, 2001, 2:01 am
- Location: aylmer ontario
- Contact:
Parts For Sale!
well project BP is just starting
-
- Regular Member
- Posts: 215
- Joined: December 28th, 2003, 2:01 am
- Location: St.Petersburg, FL
- Contact:
Re: Parts For Sale!
if your selling it by parts, how much for the clutch and air fuel gauge?
- D_Gagne
- Regular Member
- Posts: 312
- Joined: May 6th, 2003, 2:01 am
- Location: bonnyville,alberta
- Contact:
Re: Parts For Sale!
also if ur selling it by parts how much for the header for the bp and the ecu and engine? thanx
92 mx3,lime green paint 18 inch motegi mr7's,blitz front n rear bumper,fx side skirts,isotta wheel,ractive seats,ractive gtr aluminum wing,apexi exhaust, www.cardomain.com/id/livin_lime_mazda
-
- Regular Member
- Posts: 66
- Joined: November 5th, 2001, 2:01 am
- Location: aylmer ontario
- Contact:
Re: Parts For Sale!
Well i would prefer to sell all of it in one just because then it's all out of my hair at once..
but if i was going to sell it all piece by piece
BP motor (bought with 95000kms)
ported and polished ---- $500
tranny (100000kms)--- $200
5" monster auotmeter tach --- $300
air/fuel gauge ---- $40
EVERYTHING ELSE STILL IN BOXES
center force dual friction clutch --- $450
clutch masters 10lb flywheel --- $700
all driveahfts and half shaft --- $250
pilot and throwout bearing - $15
Ecu -- $20
header --- $200
but im not sure if i want to sell seperately
but if i was going to sell it all piece by piece
BP motor (bought with 95000kms)
ported and polished ---- $500
tranny (100000kms)--- $200
5" monster auotmeter tach --- $300
air/fuel gauge ---- $40
EVERYTHING ELSE STILL IN BOXES
center force dual friction clutch --- $450
clutch masters 10lb flywheel --- $700
all driveahfts and half shaft --- $250
pilot and throwout bearing - $15
Ecu -- $20
header --- $200
but im not sure if i want to sell seperately
well project BP is just starting