lagging under power/ back fire?

V6 Technical/Performance Discussions
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

how do you confrim if all the lights on the dash are hooked up to the ecu? on the right side you have oil,seatbelt, etc. on the left side i have no lights that come on at all
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
User avatar
Daninski
Supporting Member
Posts: 7055
Joined: June 18th, 2007, 10:51 am
Location: Trenton ON.

Re: lagging under power/ back fire?

Post by Daninski »

Ok, so your idle should be at 700 then adjust your timing. Not sure where the timing would sit at 1000 rpm maybe someone can check their car if they have a moment. The disty from the MX6 is the same as the one listed for the 03 MX3 and that's true up to around 96 on the MX6.
2004 Subaru WRX Silver, stage 2, minty interior.
2002 Subaru WRX Blue, SOLD (best E test numbers I've ever seen)
94 MX-6. Sold
92 GS KLZE 5 Speed
96 GS 5 speed, KLZE, Sold
95 GS Minty Shape Sold
92 GS Sold
92 GS Parts Car scrapped.
Feedback viewtopic.php?f=37&t=66348" onclick="window.open(this.href);return false;
7477th member.

I know you believe that you understand what you think I said but I'm sure you realize that what you heard is not what I meant.
RX8SE3P
Regular Member
Posts: 912
Joined: April 9th, 2007, 8:11 am

Re: lagging under power/ back fire?

Post by RX8SE3P »

Tons of different ways to wire up a HEI? There's only two ways, in which the 93-4 have two wires on the 3 pin plug wired a certain way, then 95 has those two wires swapped over.

You also don't have to hack the wires, many people have no clue that you can actually remove each wire from it's connector plug by carefully prying off the orange plate in front, then once that's off you have two hook type bits of plastic that hold each wire in. You get some small tweezers and pry those open whilst pulling on the wire and it will come out.
1995 Eunos 30x KLZE
Worklog
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

is there a FAQ or a step by step on how to do it for a 94 ze?
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
User avatar
Daninski
Supporting Member
Posts: 7055
Joined: June 18th, 2007, 10:51 am
Location: Trenton ON.

Re: lagging under power/ back fire?

Post by Daninski »

RX8SE3P wrote: whilst pulling on the wire
10 points for using the word 'whilst' in proper context :lol:
2004 Subaru WRX Silver, stage 2, minty interior.
2002 Subaru WRX Blue, SOLD (best E test numbers I've ever seen)
94 MX-6. Sold
92 GS KLZE 5 Speed
96 GS 5 speed, KLZE, Sold
95 GS Minty Shape Sold
92 GS Sold
92 GS Parts Car scrapped.
Feedback viewtopic.php?f=37&t=66348" onclick="window.open(this.href);return false;
7477th member.

I know you believe that you understand what you think I said but I'm sure you realize that what you heard is not what I meant.
RX8SE3P
Regular Member
Posts: 912
Joined: April 9th, 2007, 8:11 am

Re: lagging under power/ back fire?

Post by RX8SE3P »

mazdaspeed23 wrote:is there a FAQ or a step by step on how to do it for a 94 ze?
94 is 94. There are no ze de k8 differences, all that matters is the year of your car, which would dictate the year of your wiring loom. I used one of the diagrams by that nd4spd fellow. It's a very clear diagram.
1995 Eunos 30x KLZE
Worklog
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

Can a bad disty cause back firing? http://youtu.be/a0tKWLxfocc
back fire is crazy, its not only doing it with WOT now, its doing it as soon as the car starts.
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
User avatar
mx3_ryder
Regular Member
Posts: 371
Joined: November 2nd, 2012, 8:40 am
antispam: No
Location: Troy, VT

Re: lagging under power/ back fire?

Post by mx3_ryder »

mazdaspeed23 wrote:Can a bad disty cause back firing? http://youtu.be/a0tKWLxfocc
back fire is crazy, its not only doing it with WOT now, its doing it as soon as the car starts.
I always noticed my car sounded like a Subaru when the distributor was misfiring...
Never seemed to backfire, but also never held at "WOT".
Have you pulled a lead while car is idling to see if you have good spark?
You're looking for a steady blue spark... Its that simple.
If you've got good spark then start look'in elsewhere. Could be fuel related.
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

It never started untill I cleaned the disty. Maybe ill start there. Replace it if it doesnt work then ill go on to the next thing. It used to happen with WOT but now its doing it no matter what
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
davmac
Regular Member
Posts: 551
Joined: January 15th, 2008, 6:45 pm
Location: Twin Cities, MN

Re: lagging under power/ back fire?

Post by davmac »

Do you still have a catalytic converter on this car? The bogging down under acceleration and backfiring are symptoms of an exhaust restriction.

There is a difference between backfiring and misfiring. If I understand this post there is backfire and loss of power under load and it is getting worse. My guess is that it is getting worse because the exhaust restriction is getting worse. If the catalytic converter is coming apart inside it can create more exhaust restriction over time.

If this is misfire then ignore me and carry on with disty replacement.
Image
Proud owner of a Faded Red 92 MX-3 GS
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

its a back fire. it sounds like someone is shooting a gun from th muffler. like pop pop pow. also just did fuel pressure test and its good.
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
User avatar
Daninski
Supporting Member
Posts: 7055
Joined: June 18th, 2007, 10:51 am
Location: Trenton ON.

Re: lagging under power/ back fire?

Post by Daninski »

Just replace the disty or do the HEI mod. If you look at the schematics you'll figure it out I'm sure. You've had so many disty related problems I think the HEI mod is way past due. Cheers :D
2004 Subaru WRX Silver, stage 2, minty interior.
2002 Subaru WRX Blue, SOLD (best E test numbers I've ever seen)
94 MX-6. Sold
92 GS KLZE 5 Speed
96 GS 5 speed, KLZE, Sold
95 GS Minty Shape Sold
92 GS Sold
92 GS Parts Car scrapped.
Feedback viewtopic.php?f=37&t=66348" onclick="window.open(this.href);return false;
7477th member.

I know you believe that you understand what you think I said but I'm sure you realize that what you heard is not what I meant.
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

lmao i hear ya there. this is the 4th disty
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

yes i do have a cat on the car. I also did a compression test tonight, fuel pressure test, line test, hold test, FPR test. an they all turned out normal.

is our disties the 1.8 Liters and w/.526" Diameter Rotor Cam? im buying a new one, and everyone keeps asking me for different diameter rotor cams? im not sure what one is the right one
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
User avatar
mazdaspeed23
Regular Member
Posts: 542
Joined: June 21st, 2010, 1:27 pm
antispam: No
Location: Picton
Contact:

Re: lagging under power/ back fire?

Post by mazdaspeed23 »

well guys got some good/bad news. Good news is i got a new disty $400 took the problem away, however its the wrong disty, car wont time correctly and takes forever to start, its off by 20 degrees for timing. So return time, this time i will try a disty for a 94 mx-6 2.5l hope this works. Wish me luck
Own
1994 MX-3 GS swapped ZE
1994 MX-3 GS Swapped ZE (Gone)
1996 Dodge Dakota Sport v8 Magnum
2007 Ford Fusion SE

WORK LOG: http://mx-3.com/phpBB3/viewtopic.php?f=46&t=81232
Image

My MX-3 is nothing without me, and i am nothing without my MX-3
Post Reply

Return to “V6 Technical/Performance”