Would the spark plug wires from a mx6 work ok a Mx3?
If not are their any good ideas it their??
Spark plug wires question
- MazdaRider
- Regular Member
- Posts: 148
- Joined: August 31st, 2008, 2:52 am
- Location: San Antonio
- Contact:
- mx3_ryder
- Regular Member
- Posts: 371
- Joined: November 2nd, 2012, 8:40 am
- antispam: No
- Location: Troy, VT
Re: Spark plug wires question
Yes they will fit. Back three wires are longer I believe but will work. ![Smile :)](./images/smilies/icon_smile.gif)
![Smile :)](./images/smilies/icon_smile.gif)
- MazdaRider
- Regular Member
- Posts: 148
- Joined: August 31st, 2008, 2:52 am
- Location: San Antonio
- Contact:
Re: Spark plug wires question
I found some 10.2mm
Mx6 wires would that be too much??
Mx6 wires would that be too much??
- Nd4SpdSe
- Senior Member
- Posts: 11212
- Joined: May 25th, 2002, 2:01 am
- Location: Québec City, Quebec, Canada
- Contact:
Re: Spark plug wires question
People like to use Mx-6 wires cause they're longer, so they run better. Mx-3 wires can be a little tight, especially if you want to route them around nicely.
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
Re: Spark plug wires question
MX-6 wires are the way to go. The MX-3 ones are crap because you have to route them over the manifold due to the length and it looks messy IMO.
1995 Eunos 30x KLZE
Worklog
Worklog