Swaybar uninstallment

[WhiteFinish]

Hi Guys,

I want to install my Whiteline swaybar but getting my OEM off is a pain !!

I have tried several thing but just can't get it off.

The bolt is in somekind of joint that moves around. So the nut won't come off the bolt and I can't get the oem swaybar off





Any tips ?

[Inodoro Pereyra]

When everything else fails...

http://www.harborfreight.com/4-1-2-half ... 95578.html

[WhiteFinish]

Look at the 2nd picture

[Inodoro Pereyra]

Not enough room?
You could try with a nut cracker...

http://www.harborfreight.com/7-8-eighth ... 66419.html

[Ryan]

When everything else fails...

http://www.harborfreight.com/4-1-2-half ... 95578.html

Funny, when it comes to end link replacement, thats the tool I pick up first...

[Inodoro Pereyra]

Of course. There's no reason not to have some fun while working...

[Ryan]

Its like I told you earlier, I'm just ridiculously impatient with machines

[mikeinaus]

if you dont have a grinder grab a big hammer and bash the cap off the ball joint, using a flat head screwdriver as a punch. then grab the ball with vice grips and wrench it off like any other rusted bolt...

[Inodoro Pereyra]

Its like I told you earlier, I'm just ridiculously impatient with machines

Hmmm... I just love the grinder. I'm a 100% no nonsense kind of guy, and the angle grinder is a 100% no nonsense kind of machine. A match made in Heaven...

if you dont have a grinder grab a big hammer and bash the cap off the ball joint,

I would most definitely NOT recommend using a BFH underneath a car on jack stands, ever. First, because in that position you will end up hitting your knuckles a lot more than the car, and second, because the vibration could knock the car off one of the jack stands, and on top of you. Not a good idea.

[Nd4SpdSe]

I tried many ways to get those links off, the only way that works...cut it

[Sleeper6]

Ya those are a pain and I would just get new sway bar links they are usually cheap enough anyhow. There supposed to have an insert at the end of the stud to put a n allen key and use a wrench on them but if they are shot your best bet is to cut them off and use new ones

[WhiteFinish]

If I cut them off than I'd have to find a way to loosen the bolt on the other end... (same problem)

[Nd4SpdSe]

If I cut them off than I'd have to find a way to loosen the bolt on the other end... (same problem)

Cut off the bolt

[bbunkerc397]

That looks very rusted, I just did a lot of work replacing my bushings and I had to remove a link to get the arm off. I used WD-40 & wire brushed the threads, with a 5mm Allen key and a 14mm wrench as able to get the nut off with damaging the link.

[bbunkerc397]

If your looking to save the link and if all else fails using a small tip on a torch, if you got one at your disposal try heating it up a little that might work.