I had to replace my distributor and i want to adjust the ignition timing to the correct setting..
My problem is i cant see the timingmark!
Both the chiltons and my original workshopmanual, says that the mark should be a yellow mark on the crankshaftpulley but its a bit rusty and maybe thats why i cant find the mark anymore....
When i look closely at the schematics in the manual, it does however look more like the mark is a small indentation on the crankshaftpully on the side towards the timingscale "i cant see that either"
![Confused2 :confused2:](./images/smilies/confused2.gif)
So can anyone of you super-mxérs tell me what the timingmark should look like??
If its a indentation in the pully i can lightly brush away the rust untill i find it but if its a yellow mark it is gone due to light surfacerust
![Crying :crying:](./images/smilies/crying.gif)
What to do then, is the timingmark in some logic position on the pully so that i can find it and remark it?
Any help is appreciated.