This forum is for discussion of topics relating to MX-3 lighting such as Headlights, Tail lights, Accessory Lights, Interior Lights, Etc. For example, Rear Euro Altezza Style Tail lights, Headlight units, LED's, HID's, Bulbs, Interior lights, Neons, Strobes, Auxillary Lights/Fogs or anything filament and gas discharge related.
Also anything dealing with the elctrical system.
So i bought this altezza's years ago but lately after looking at other pics and considering the halo headlights i was wondering if this gap is gonna be a issue with the headlights too? and im tempted to buy another set of tailights if it will get rid of the gap....i forgot where i bought them from...
Did you install them correctly? Make sure its in all of the clips properly... my aftermarket tails fit fine.
There is no link between the people who make the tail and the headlights.
One style of headlights is a bit smaller, but they both fit good.
Now with Moderator power!
Black '93 BP RS - wrecked, parted, scrapped.
Green GS - Sold.
Black GS - Summer DD/Race car - Fancy KLZE
Red GS - K8-ATX -> MTX-KLDE - Frakencar. Scrapped
White GS - Rusty. Parts. Scrapped
1997 BMW M3 - my summer baby
2002 BMW 325Xi - sold
2003 Forester Xti - EJ20K swapped. Feedback
im 99% sure i installed them properly...the clips lined up with the bar's body and it only has that one screw that screw's into the car towards the center of the car...just seems real shady...one screw to hold the entire piece in...
well it only requires one screw cause those clips hold it in damn good, how did you uninstall them? by sliding it or pulling? (if you pulled them out, you may need new clips)
Yea its pushed in all the way. if you look at the first pic you can see the taillight liner is lined up with the hatch lining. if you run your hand across is flush with the car its just that gap...
There are two styles (that i have seen), one set pushes in from the back of the car to the front, the other set pushes from the middle of the car toward the outside of the car sideways. I have had both set's and the one's that push from the back to the front had a huge gap in fitting, these were my carbon fiber looking one's.