coolant pot question, by the disty.

H_type · Post by **H_type** » January 12th, 2009, 12:35 am

I am finishing a swap on my buddys car, i dont think this port was on the last motor. any one tell me where this goes to and maby even post a photo.. i have been searching quite some time and need some help. thanks guys!

RX8SE3P · Post by **RX8SE3P** » January 12th, 2009, 12:57 am

Telling us what kind of engine you put in would help a little. Then I could check my own engine if it's the same.

solo_ryder · Post by **solo_ryder** » January 12th, 2009, 1:20 am

I had that on my old ze/de millenia. I plugged it with some JB weld and a screw.

H_type · Post by **H_type** » January 12th, 2009, 1:54 am

really just plug it? thanks I hope your correct, but from all the good posts you help out with im willing to put my money on ya. thanks solo.

solo_ryder · Post by **solo_ryder** » January 12th, 2009, 10:16 am

Haha yea plug it. I think its for the auto tranny on the millenia or a part of the rad that we do not have. plug it.

marcdh · Post by **marcdh** » January 12th, 2009, 11:11 am

haha oh wise solo! yep pretty sure I read before that's for the auto tranny, it's plugged on mine too.

Daninski · Post by **Daninski** » January 12th, 2009, 12:35 pm

Or slide a short piece of rubber hose on the tube. Clamp it then plug the other end with a bolt and clamp it as well.

MX-3.com

coolant pot question, by the disty.

coolant pot question, by the disty.

Re: coolant pot question, by the disty.

Re: coolant pot question, by the disty.

Re: coolant pot question, by the disty.

Re: coolant pot question, by the disty.

Re: coolant pot question, by the disty.

Re: coolant pot question, by the disty.