How can i slow my signal lights down, flashing too fast

rusty · Post by **rusty** » September 27th, 2007, 8:31 pm

So i tryed switching the resistor that we talked about above and it made not difference. The stock resistor was a 51ohm, i tryed a 27ohm, 10ohm, 1.5ohm resistor and they all flash at the same speed. So

I need help to disable the load sensing circuit in my flasher so it will flash at a normal speed. I have installed LED turn signals and it flashs really fast.

shameem · Post by **shameem** » September 27th, 2007, 9:15 pm

I couldnt get the focus thing on my camera to work properly - but i took several images.

Basically there is a transistor (small black thing with three legs) in the circled area - you just cut the outermost leg.

rusty · Post by **rusty** » September 27th, 2007, 9:32 pm

Wow thanks for the help, that worked perfect. Definetly the cheapest and easiest route to fixing the problem. How in the heck did you ever figure that out.

shameem · Post by **shameem** » September 28th, 2007, 8:24 am

Lot of vodka was involved

stephen-mx3 · Post by **stephen-mx3** » August 26th, 2008, 2:03 pm

i now this is one old a-- thread, but is this?!

i dont fancy buying 6 of those load resistors!!

wytbishop · Post by **wytbishop** » August 26th, 2008, 2:24 pm

Just get higher viscosity blinker fluid.

neli_nael · Post by **neli_nael** » August 26th, 2008, 3:33 pm

shameem wrote:P.S. - I was ok with my leds flashing faster than normal till i got pulled over and "warned"......

yea i thought it was illegal so have fast blinkers...hyper blink

MX-3.com

How can i slow my signal lights down, flashing too fast

Re: How can i slow my signal lights down, flashing too fast

Re: How can i slow my signal lights down, flashing too fast

Re: