transmission solenoids? sensors?

A forum for discussions regarding the MX-3' transmission. Swap, technical, and troubleshooting info should be placed here.
Post Reply
Gods Father
Regular Member
Posts: 126
Joined: August 6th, 2007, 2:01 am
Location: Boston, Massachusetts

transmission solenoids? sensors?

Post by Gods Father »

so ive noticed something...therees 3 sensors or somethin on the transmission...2 are exactly the same just in different spot and im trying to figure out what they do cause the wires ripped out of it when i was pullin the engine (couldnt get the connectors seperated and was a little pissed so i said F it ill fix it later; now im paying for it) so anyways theres 2 green wires coming from both sensors and there seems to be no telling either green wire apart...does anyone know what these do? and how bad i need them haha thanks...

ill post pictures if need them, once i get them...
1993 MX-3 w/ straight neck KLZE swap...Probe GT 2.5in headers, Custom exhaust w/ test pipe and OBX Twin Loop Tip, Bully Stage 3 Clutch, Fidanza Flywheel, Pheno Spacers, HEI mod, Blaster SS coil, Probinator chip, TWM short shifter, AWR front and rear mounts (88 Durometer), and Corksport braided clutch line...so far

Ever see the lone rider of the night? Well he'll find you and then you'll never him again...
User avatar
shameem
Supporting Member
Posts: 820
Joined: May 9th, 2007, 9:59 pm

Re: transmission solenoids? sensors?

Post by shameem »

Is it auto or manual?

If its manual - then it could be speedo sensor, reverse light switch and neutral safety switch. There might be a ground strap there too.
Image
Gods Father
Regular Member
Posts: 126
Joined: August 6th, 2007, 2:01 am
Location: Boston, Massachusetts

Re: transmission solenoids? sensors?

Post by Gods Father »

yea its a manual...two of them are identical and the 3rd one is like part of the block it looks like...but both wires are the same and pulled straight out of the plug and straight off of the sensor so even if there was telling them apart theres still no way of knowing where they go...where could i buy one of these?
1993 MX-3 w/ straight neck KLZE swap...Probe GT 2.5in headers, Custom exhaust w/ test pipe and OBX Twin Loop Tip, Bully Stage 3 Clutch, Fidanza Flywheel, Pheno Spacers, HEI mod, Blaster SS coil, Probinator chip, TWM short shifter, AWR front and rear mounts (88 Durometer), and Corksport braided clutch line...so far

Ever see the lone rider of the night? Well he'll find you and then you'll never him again...
Post Reply

Return to “Transmissions”