i have a custom made hatch cover made from mdf.. top part is fiberglassed and there are 11" holes cut out to fit 12" sub woofers in free air
was using them for a bit but i am going with boxes instead
any offers?
[FS] hatch cover mdf for subwoofers [feeler]
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
It would cost alot more to ship than it would to buy a piece of MDF from Home Depot. It is finished and looks good, so I hope I didn't ruin your FS.
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP
no, but it also wouldn't be hard to finish that box and seal it up.... fiberglass the one part there where you can see (where the hatch latch is), make that your spot for your amp so you can see it, hide a light or something there to illuminate the amp for looks, and STILL make it removable if you wanted...
good paltform to start with.
good paltform to start with.