Quick question...
Will a MX6 B&M short shifter fit the Mx-3?
i only ask cause i have the chance to buy a mx6 shifter for $15
Short Throw
-
- Regular Member
- Posts: 187
- Joined: October 12th, 2005, 2:09 pm
- Location: Bellingham, WA
Short Throw
I still cant find anywhere in the shop manual where it says there should be a 1in hole in the side of the block. (Blown K8) #6 rod thrown through block.
- 1992blazeredgs
- Regular Member
- Posts: 598
- Joined: June 25th, 2005, 3:44 pm
- Location: Birmingham, AL
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
I'm almost 100% that they do. Look at B&M's website for the part number of the MX-6 and MX-3 versions. If the part numbers are the same then the shifter is the same.
![Image](http://www.patdiesel.atlantamx3.com/MX-3/patdieselsigMX-3.jpg)
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP