Made myself engine crossmember bushing
- Yoda
- Regular Member
- Posts: 853
- Joined: January 4th, 2003, 2:01 am
- Location: Earth, solar system, Milkyway, etc
Made myself engine crossmember bushing
As many of you know when you remove the front cross member to change engine mounts the 4 rubber bushing are pretty much history. Having have/ had a half dozen car with these bushings I finally decided to do something about it. I made an epoxy molds and cast a set 2 piece urethane bushing at my friend urethane manufacturing shop. I've installed a set in the ZX2 which got rid of an annoying clunking sound and threw the other set in the box of parts to be installed on the MX-3. Unfortunately my companies urethane division and my friend are not interested in producing these bushing is any greater qty than I can use myself.
- atlantamx3
- Supporting Member
- Posts: 2888
- Joined: June 2nd, 2001, 2:01 am
- Location: Kennesaw, Ga, USA
- Contact:
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
Would you be willing to sell the 2 piece mold? It is easy enough to mix and pour urethane. I'd make them and sell them on here.
![Image](http://www.patdiesel.atlantamx3.com/MX-3/patdieselsigMX-3.jpg)
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP