[WTB] LSD Differential V6
- Ice Racing
- Regular Member
- Posts: 104
- Joined: November 7th, 2006, 11:31 pm
- Location: Québec
[WTB] LSD Differential V6
Looking for LSD to put in a manuel ZE.
Last edited by Ice Racing on November 29th, 2006, 7:56 pm, edited 1 time in total.
GS KLZE FOR ICE RACING
- Ice Racing
- Regular Member
- Posts: 104
- Joined: November 7th, 2006, 11:31 pm
- Location: Québec
lsd
That's what i have ear from one other guy. i would like to know more about that (size of shaft, ratio, ...)
GS KLZE FOR ICE RACING
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
They fit, but there are a few things thst need to be done to get it in there and a thing or two that should be done to make it perform without failure. There are a few that have done it and posted good info on what they did and why. A search should bring up what you need. I'd look for MS LSD in the V-6 forum.
![Image](http://www.patdiesel.atlantamx3.com/MX-3/patdieselsigMX-3.jpg)
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP
- Ice Racing
- Regular Member
- Posts: 104
- Joined: November 7th, 2006, 11:31 pm
- Location: Québec
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
Basically, you need to grind a bit of the trans case so that something will fit (can't remember which part rubs). Then you need to buy the bolt kit for the MS LSD and weld something together so that it will not come apart.
![Image](http://www.patdiesel.atlantamx3.com/MX-3/patdieselsigMX-3.jpg)
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP