[FS] Stage 1 Competition Clutch kit for 1.8 DOHC BP motor

Mazda_Powered · Post by **Mazda_Powered** » November 8th, 2006, 1:12 pm

Up for grabs!

Clutch retails for over $300US, i got it for $290CDN. BUT you can get it for the low price of $250CDN. I'm not going to ship this out. I can arrange pick up or possibly meet 1/2 way.

I bought this clutch about 3 months ago for my protege GT, but i'm not keeping the protege, so i dont need the beefier clutch anymore.

Holds 40-50% over a stock clutch (250whp range).

Clutch has never been used, brand new in the box.

Here's the specs on their stage 1 clutches.

Gravity Series 2400 Clutch Kit
The CC Gravity 2400 series kit is the economical solution for moderately increased cars and/or stock cars driven in an aggressive manner. This clutch system will safely guarantee 40-50% increase in torque capacity and still deliver extended life.

This kit includes a Competition Clutch pressure plate, a 6 pad Carbotic high-torque performance disc assembly, all applicable bearings and the appropriate alignment tool.

Here's the actual product im selling.

http://www.competitionclutch.com/produc ... able+for+y our+4+cylinder+Mazda+Miata+%281994-2003%29+1.8L%21

Just email or PM me X_EGT_EVO_X@msn.com

JACK.

I'm located at Balm Beach, ontario. Which is 30 mins north of Barrie.

Mazda_Powered · Post by **Mazda_Powered** » November 9th, 2006, 10:27 am

nobody doing a bpt or a bp swap? this is pretty cheap guys! just a factory B6 replacement clutch kit is over $200!

TTT!

JACK.

Red_MX3_92 · Post by **Red_MX3_92** » November 9th, 2006, 9:24 pm

ITERESTED!!!

But i was wondering if it would fit in the b6 1.6 dohc mx3 tranny caz with the swap the escort gt comes with auto tranny or what should i do...

Red_MX3_92 · Post by **Red_MX3_92** » November 9th, 2006, 9:27 pm

and where u located

Mazda_Powered · Post by **Mazda_Powered** » November 9th, 2006, 10:06 pm

the only way you'll be able to use the BP DOHC clutch kit on your B6 DOHC is if you have a BP DOHC transmission.

I'm 30 mins north of barrie.

Mazda_Powered · Post by **Mazda_Powered** » November 9th, 2006, 10:10 pm

also, i know where there's a couple BP DOHC powered cars at a wreckers, you'd need tranny and axles.

JACK.

Red_MX3_92 · Post by **Red_MX3_92** » November 9th, 2006, 11:03 pm

i c thanx for the info i'm gona go to the scrapers here in hamilton and check em out for the tranny and axles but yea once i find those and get the price figured then i'll get back to yea about the clutch caz i might just stick with my old 5spd tranny for a bit caz i recently got a new clutch in there...

Mazda_Powered · Post by **Mazda_Powered** » November 9th, 2006, 11:15 pm

no problem!

*** CLUTCH HAS BEEN SOLD/PENDING from an outside buyer ****

JACK.