rear spolier

A forum for Appearance Discussions. (Exterior, Body Kits, & Interior)
Post Reply
jnic
Regular Member
Posts: 38
Joined: December 28th, 2001, 2:01 am
Location: Barrie, Ontario

rear spolier

Post by jnic »

I know this is probably a stupid question but how do I remove the spoiler on the v6 stock
User avatar
Nd4SpdSe
Senior Member
Posts: 11212
Joined: May 25th, 2002, 2:01 am
Location: Québec City, Quebec, Canada
Contact:

Post by Nd4SpdSe »

you need to take off the plastic panels on the hatch and it will reveal 4 bolts from the underside, just unbolt them and it'll come off.
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
User avatar
jschrauwen
Forum Moderator
Posts: 6052
Joined: September 27th, 2003, 2:01 am
Location: Frankford, Ontario, Canada
Contact:

Post by jschrauwen »

Nd4SpdSe wrote:you need to take off the plastic panels on the hatch and it will reveal 4 bolts from the underside, just unbolt them and it'll come off.
Ahem, 6 nuts to remove from permenant studs.
'92 GS-ZE - sold, '95 GS - sold, '02 Protege LX - Daughter, '00 Audi A4 2.8 QTip, Ducati TT2
Image
90 JDM RHD 300ZX TT - 572.1 RWHP | 590.0 RWTQ | 21 PSI | Pump gas
ninjajim4
Regular Member
Posts: 1163
Joined: December 18th, 2004, 2:01 am

Post by ninjajim4 »

ohhhhhhhhhhh

PWNED!!

jk.. :)
markbrad
Junior Member
Posts: 17
Joined: January 29th, 2006, 7:34 pm
Location: Ohio
Contact:

Post by markbrad »

Will a GS spoiler bolt right on to an RS body?
User avatar
neutral
Supporting Member
Posts: 1770
Joined: December 27th, 2004, 10:19 am
Location: U.S. Mid Atlantic

Post by neutral »

markbrad wrote:Will a GS spoiler bolt right on to an RS body?
yup. Direct fit by replacing the RS smooth hatch garnish with any of the GS spoilers.
Image -Jim
precidian
Regular Member
Posts: 420
Joined: November 7th, 2000, 2:01 am
Location: London, ON, Canada
Contact:

Post by precidian »

the question no one has asked, which GS spoiler are you wanting to remove? Also, with the GS spoiler, there are two additiondal screws under small round covers close to the front of the spoiler.

1. Image
2. Image
3. Image


If a 94 GS spoiler is going to be put on, then some drilling will be required.
Tom S. - '94 MX-3 GS-X Sparkle Green

Image

I say, Ahmed. What is that thing you do when you're about to assassinate an infidel?
Post Reply

Return to “Appearance”