quick question

General Mazda MX-3 Discussions
Post Reply
User avatar
mx3stylez
Regular Member
Posts: 114
Joined: October 31st, 2005, 4:56 pm
Location: edmonton, alberta

quick question

Post by mx3stylez »

how many post do i have to do before i can post in buy/sell?
klze swap, wisco 8.5 comp pistons, pauter rods, act stage 3 clutch, lightened flywheel, UR racing pulley, flex-o-lite oil cooler, 2.5" custom exhaust with high flow cat, B&M short throw shifter, S&R cross drilled rotors, , B&G lowering springs, maxxim 17" gun metal rims, modded nissan injectors, walbro 255 lph fuel pump, areomotive afpr, msd 6a , magasquirt v3, and turboed
Bochek
Regular Member
Posts: 1704
Joined: December 31st, 2005, 5:54 pm
Location: Burlington + Grimsby, Ontario, Canada
Contact:

Post by Bochek »

READ THE STICKY!!!!!! OMFG

n00bs

Bochek
User avatar
mx3stylez
Regular Member
Posts: 114
Joined: October 31st, 2005, 4:56 pm
Location: edmonton, alberta

Post by mx3stylez »

thanks alot there old timer
klze swap, wisco 8.5 comp pistons, pauter rods, act stage 3 clutch, lightened flywheel, UR racing pulley, flex-o-lite oil cooler, 2.5" custom exhaust with high flow cat, B&M short throw shifter, S&R cross drilled rotors, , B&G lowering springs, maxxim 17" gun metal rims, modded nissan injectors, walbro 255 lph fuel pump, areomotive afpr, msd 6a , magasquirt v3, and turboed
User avatar
mx3stylez
Regular Member
Posts: 114
Joined: October 31st, 2005, 4:56 pm
Location: edmonton, alberta

Post by mx3stylez »

30 posts is quite a few post if you don't really have any questions
klze swap, wisco 8.5 comp pistons, pauter rods, act stage 3 clutch, lightened flywheel, UR racing pulley, flex-o-lite oil cooler, 2.5" custom exhaust with high flow cat, B&M short throw shifter, S&R cross drilled rotors, , B&G lowering springs, maxxim 17" gun metal rims, modded nissan injectors, walbro 255 lph fuel pump, areomotive afpr, msd 6a , magasquirt v3, and turboed
User avatar
mx3stylez
Regular Member
Posts: 114
Joined: October 31st, 2005, 4:56 pm
Location: edmonton, alberta

Post by mx3stylez »

btw, i am not that new, i have been a member under another name for a couple of years. i just read about what other people are asking about and learn from there instead of asking questions all the time. its better than getting shitted on for asking a question that allready has an answer. i just didn't see that sticky, otherwise i wouldn't have asked.
thanks again,
travis
klze swap, wisco 8.5 comp pistons, pauter rods, act stage 3 clutch, lightened flywheel, UR racing pulley, flex-o-lite oil cooler, 2.5" custom exhaust with high flow cat, B&M short throw shifter, S&R cross drilled rotors, , B&G lowering springs, maxxim 17" gun metal rims, modded nissan injectors, walbro 255 lph fuel pump, areomotive afpr, msd 6a , magasquirt v3, and turboed
Post Reply

Return to “General Mazda MX-3”