headbolts
-
facko
- Regular Member
- Posts: 224
- Joined: February 27th, 2005, 1:25 pm
- Location: beaufort, sc
- Contact:
headbolts
anyone kno the torque specs for the head bolts on the dohc 1.6? thx
BP swap -- Pacesetter Header -- Custom CAI -- Custom 2.5 Exhaust w/ a Thrush Glasspack and 40 Series Flowmaster -- SPEC Stage 2 Clutch Kit
76-81 ft lbs its in the oline shop manual page b1-079 
95 rs with custom short ram air, b&m short throw shifter, probe 2.0L header with 2 1/4" exhaust all the way back, catco high flow cat, apc high flow muffler with 4.5" tip, accel 8 mm wires, blaze red, cf altezzas, gun metal 17" mr7s, slotted cross drilled rotors on the way with hawk hps pads, red and white interior, other then that its stock.
-
PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
That means start at 76 ft/lbs and work up to 81. Don't go straight to 81 or you chance snaping one or stripping it. Also are you sure that is not inch pounds??? That sounds like alot fo torque for a aluminum head to take...
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP