[WTB] KL-ZE distributor and harness. (external coil type)

Ateana · Post by **Ateana** » August 28th, 2005, 5:52 pm

KL-ZE distributor and harness. (external coil type)

hppwdn · Post by **hppwdn** » August 28th, 2005, 5:58 pm

I think I have one, but I don't have cap. It was broken when I got my ZE. If you want the disty let me know and I'll try and find it. I think I know where it is, just haven't actually looked at it in awhile.

Ateana · Post by **Ateana** » August 28th, 2005, 6:06 pm

yeah i have a cap but i dont have a wire harness either? oh hey if your using an msd 6 and blaster 2 coil i need some info too if you dont mind

hppwdn · Post by **hppwdn** » August 29th, 2005, 12:06 am

My ZE disty is apparently gone. You can do an external coil set-up without the ZE disty. If you have the cap with the spot for the coil the hardest part is over.

Look over on Probetalk for MSD installation threads and you should find more than enough info.

I don't know what year your car is, but the wiring does vary by year.

babyblueMX3 · Post by **babyblueMX3** » August 29th, 2005, 8:02 am

Ateana wrote:yeah i have a cap but i dont have a wire harness either? oh hey if your using an msd 6 and blaster 2 coil i need some info too if you dont mind

why the harness ? if it's for the ze disty then you don't need it. just hack the stock stuff and you'll be good to go..at least I did

Ateana · Post by **Ateana** » August 29th, 2005, 1:58 pm

because my kl-ze disty has a bad cam angle sensor and i just bought the car they person i bought it from tried installing a disty with an internal coil so i had those harnesses attached... he did include the kl-ze disty but not the four pin harness

babyblueMX3 · Post by **babyblueMX3** » August 29th, 2005, 2:27 pm

you don't need a 4 pin harness..just go to the junk yard find a mx-3, snip the fuel rail clip. It is the same as the klze 4 pin connector

that's the one I'm using

Ateana · Post by **Ateana** » August 29th, 2005, 5:56 pm

sweet now all I need is a new klze disty

and i will take a trip to the junkers.. hey by any chance are you ryan.. used to live in mississauga? well bordering oakville off winston churchill

[edit] nm your steve my bad..

Slammed6 · Post by **Slammed6** » August 31st, 2005, 11:47 pm

i have a KLZE disty and cap...its in my back yard, i puled it off my ZE i just installed. Make me an offer

hgallegos915 · Post by **hgallegos915** » September 1st, 2005, 3:03 pm

I have a pretty good kfze externam coil disty..same as klze, except the cap has the coil thingy cracked ..I dont need it AT ALL..you can have it for any price... like my old ze...this will go to the trash can if no one gets it..