what rim size should I get?

This forum is for Discussion on Suspension issues.
Ryencool
Regular Member
Posts: 666
Joined: December 11th, 2000, 2:01 am
Location: fairport , ny

what rim size should I get?

Post by Ryencool »

im torn between looks and performance, I have eibach springs and zx2 struts so its lowered a little..Im not sure what to grab some 15 16 or go for looks with 17's. Im more of a performance type person so im leaning twards the 15's and 16's but would 15's be too small? I want somthing in gunmetal or flat balck, maybe some rotas...any ideas of suggestions?<p>Image<p>[ April 25, 2003: Message edited by: Ryencool ]</p>
Image
92 red rs
performance exhaust
zx2 struts and Eibach springs
turboed + stand alone when the cash is there
User avatar
jpwmx3
Regular Member
Posts: 364
Joined: August 8th, 2002, 2:01 am
Location: Waterloo, Canada
Contact:

Re: what rim size should I get?

Post by jpwmx3 »

If you get 15, your just wasting your money, get 16 at least or 17's look sweet. I noticed very little ride quality difference when I went to 17.
ProtegeSTS
Regular Member
Posts: 1821
Joined: December 5th, 2001, 2:01 am
Location: Gainesville

Re: what rim size should I get?

Post by ProtegeSTS »

I like 15 x 7s...<p>
Good tire selection, cheap, light, looks good IMO, doesn't attract a ton of attention, not as likely to be stolen...
-93 MR2
#129 E-stock
torpedan
Regular Member
Posts: 1430
Joined: January 5th, 2002, 2:01 am
Location: DFW

Re: what rim size should I get?

Post by torpedan »

<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>I like 15 x 7s...<p>Good tire selection, cheap, light, looks good IMO, doesn't attract a ton of attention, not as likely to be stolen...
<hr></blockquote><p>
i second that notion.. Any bigger and your losing out on performance
-torp.
I don't own a Mazda.
mx3man83
Regular Member
Posts: 1921
Joined: August 25th, 2002, 2:01 am
Location: tucson, az

Re: what rim size should I get?

Post by mx3man83 »

Get some light 17's. If not, then at least get some 16's. 15's look stupid. It's not like your going to be racing all over the place anyways, 17's would be just fine.
Combat kit, Spectra blue paint, shaved, Black ADR flite 4 17's/ Yokahama ES 100's, straight through 2.5 inch cat back exhaust, CAI, Straight neck IM KLZE, poly filled motor mounts, Kl48/ Eprom chip, black altezzas, Wet Zex 75 shot, Walbro 255 fuel pump, Cosmo AFPR, GS SE all black interior, RF 1kbd amp, RF 12 HE2's (2), US acoustics 4 channel amp
My Cardomain site
User avatar
ryanlindenberg
Regular Member
Posts: 874
Joined: February 24th, 2003, 2:01 am
Location: Minnesota

Re: what rim size should I get?

Post by ryanlindenberg »

i like my 16x7's. gunmetal motegi MR7s. :cool:
CARDOMAIN WITH UPDATED PICS
"There are 2 kinds of pedestrians, the quick and the dead."
Ryencool
Regular Member
Posts: 666
Joined: December 11th, 2000, 2:01 am
Location: fairport , ny

Re: what rim size should I get?

Post by Ryencool »

well im still stuck on 15's or 16's, one because of the wieght issue amd two because anythign over 16 is negating performace and looks bad on the mx3 i think..everyones got there opinion and mine is based on performance ;) heh...sts got any brand you like? im liking rotas but want to find a good deal, and there goin for 475 shipped, not to bad but can i do better?
Image
92 red rs
performance exhaust
zx2 struts and Eibach springs
turboed + stand alone when the cash is there
zytariuk
Regular Member
Posts: 947
Joined: January 19th, 2002, 2:01 am
Location: Barrie, Ontario, Canada
Contact:

Re: what rim size should I get?

Post by zytariuk »

I got 17" rims on my car and I did not notice any significant performance/gas mileage drop. Go for a set of 17's.
<img src="http://members.rogers.com/zytariuk/images/mx-3.gif" alt=" - " />

1992 Mazda Mx-3 GS - Beige metallic
zytariuk's mx-3 page (updated June 12th, 2003)
ProtegeSTS
Regular Member
Posts: 1821
Joined: December 5th, 2001, 2:01 am
Location: Gainesville

Re: what rim size should I get?

Post by ProtegeSTS »

Rota, Kosei K1s, and Konig Heliums are some of the cheaper 15 x 7 choices. Go wide if you can. It's worth the extra weight.<p>If you've got money, SSR makes some badass wheels, under 10 lbs too.<p>I like 15"s. I don't care if you think they look stupid, because if that's your basis for choosing a wheel size, then YOU are stupid :shrug: (general statement, NOT directed at anyone)
-93 MR2
#129 E-stock
Ryencool
Regular Member
Posts: 666
Joined: December 11th, 2000, 2:01 am
Location: fairport , ny

Re: what rim size should I get?

Post by Ryencool »

yeah people just go for looks, and at one point i was like that. but when you think about it, drage races and rally races can be one by milliseconds, if that means making my tire smaller and wider, for better accell and more patch to the pavement im all for it. <p>Albiet I dont drag race or rally race competitively, I want my car set up so if I decide to run some SOLO races or sotmhign I can, plus it will just perform better..<p>Thanks STS, your the ****, when your not being mean haha
Image
92 red rs
performance exhaust
zx2 struts and Eibach springs
turboed + stand alone when the cash is there
User avatar
rece
Regular Member
Posts: 540
Joined: June 22nd, 2001, 2:01 am
Location: calgary

Re: what rim size should I get?

Post by rece »

def' put some 20's or bigger on it would only ad about a million pounds but at least the same in horse. :roll: jokes, id put on some enkei RPM2 at a 17 inch size and 7.5 width as they are only 7.7kg or for u americans 17lbs. i believe the stock 15's are around 18 lbs and the 17's look sweeeeeeeeet.
Jesse<BR>red 92 gs
Ryencool
Regular Member
Posts: 666
Joined: December 11th, 2000, 2:01 am
Location: fairport , ny

Re: what rim size should I get?

Post by Ryencool »

16 is as high as ill go..thats been determined ;) <p>that whole, its looks sweeeet thing, I could care less about..I can get girls without my car ;)<p>[ April 27, 2003: Message edited by: Ryencool ]</p>
Image
92 red rs
performance exhaust
zx2 struts and Eibach springs
turboed + stand alone when the cash is there
Aaron MacDougall
Regular Member
Posts: 78
Joined: June 16th, 2002, 2:01 am
Location: Nova Scotia
Contact:

Re: what rim size should I get?

Post by Aaron MacDougall »

16x7 rota slipstreams (spoon sw-388 replicas) weigh 13.5lbs. They come in silver bronze and black.<p>Image
User avatar
Nd4SpdSe
Senior Member
Posts: 11213
Joined: May 25th, 2002, 2:01 am
Location: Québec City, Quebec, Canada
Contact:

Re: what rim size should I get?

Post by Nd4SpdSe »

<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>Originally posted by Ryencool:
but when you think about it, drage races and rally races can be one by milliseconds, if that means making my tire smaller and wider, for better accell and more patch to the pavement im all for it. <hr></blockquote><p>
i dont think you can do that withough messing your speedo and maybe yoru tranny if your auto<p>the total circumpherence/dimention (depending on what you measure) must equal the same circumpherence/dimention as what is stock, lerger rim, smaller tire
1992 Mazda Mx-3 GSR - 2.5L KLZE : Award Winning Show Car & Race Car ['02-'09] (Retired)
2004 Mazda RX-8 GT - Renesis Wankel : LS3 Coils, BHR Mid-Pipe + Falken RT-615K 245/40r18
2011 Mazda Mazda2 GS - 1.5L Manual : Yozora Edition (1 of 500)
2003 Nissan Xterra SE - 4x4 Supercharged : 2" Body Lift, 4" Suspension Lift & 33" MTR Kevlar
2001 Nissan Frontier SE - The Frontrailer : Expedition/Off-Road Trailer Project
Ryencool
Regular Member
Posts: 666
Joined: December 11th, 2000, 2:01 am
Location: fairport , ny

Re: what rim size should I get?

Post by Ryencool »

exactlly, im actually looking at the 16x7 slipstreams or subzeros from rota...the slipstream was my initial thought, but the subzero looks like z06 rims, and there cool looking, opinions?
Image
92 red rs
performance exhaust
zx2 struts and Eibach springs
turboed + stand alone when the cash is there
Post Reply

Return to “Suspension/Brakes/Wheels/Tires”