clear side repeaters fitted

BADMX3 · Post by **BADMX3** » November 30th, 2003, 1:28 pm

ok the pics aren't brilliant and due to the weather my car is soooo dirty but i've customised the mazda 6 side repeaters to fit my mx here are the pics what you guys and girls think?
<img src="http://images.cardomain.com/member_imag ... 460_46.jpg" alt=" - " />
<img src="http://images.cardomain.com/member_imag ... 460_48.jpg" alt=" - " />
<img src="http://images.cardomain.com/member_imag ... 460_49.jpg" alt=" - " />

Taras · Post by **Taras** » November 30th, 2003, 5:41 pm

Looks nice. I always been in favour of fender repeater blinkers. Too bad they are not mandatory here in North America. I might attempt an LED repeater in my mirrors one day.

quicksliver · Post by **quicksliver** » December 2nd, 2003, 1:29 am

Hehe you're car looks like a monster truck not lowered with those low pros on there

. Wish mine was like right now...iv'e got stuck in the snow three times this week lol.

Pearl-JapSpec · Post by **Pearl-JapSpec** » December 2nd, 2003, 4:35 pm

yes snow does suck... my bloody rear tires have wholes in them on my stock rims so i gota go front stock rear momo

superslacker · Post by **superslacker** » December 2nd, 2003, 5:08 pm

Hehe you're car looks like a monster truck not lowered with those low pros on there . Wish mine was like right now...iv'e got stuck in the snow three times this week lol.

yes snow does suck... my bloody rear tires have wholes in them on my stock rims so i gota go front stock rear momo

whooOO! go stock GS rims and suspension!

BADMX3 · Post by **BADMX3** » December 2nd, 2003, 10:23 pm

i refuse to lower my car just yet... as i want a full kit and need to see how far it sits before lowering... as england has to have more speed humps / ramps than anywhere in the world!
your right though my car sits far 2 high lol>
guess i need 19's to fill those arches!

odds1 · Post by **odds1** » December 3rd, 2003, 6:28 am

did you have to mold anything or did the mazda 6 repeater cover the holè completely? I have seen that those are a bit smaller than the mx3 ones..

BADMX3 · Post by **BADMX3** » December 3rd, 2003, 6:43 am

they fill the gap's, the work is minimal though you don't get a seal, so i sealed it myself with sikaflex.
it leaves a mark where the origional seals wre so you may need to t-cut that... but they are well worth it and look sweet!

odds1 · Post by **odds1** » December 3rd, 2003, 7:33 pm

sealed it with sikaflex? isn´t that superglue? how will you change a broken bulb then?

MX-3.com

clear side repeaters fitted

clear side repeaters fitted

Re: clear side repeaters fitted

Re: clear side repeaters fitted

Re: clear side repeaters fitted

Re: clear side repeaters fitted

Re: clear side repeaters fitted

Re: clear side repeaters fitted

Re: clear side repeaters fitted

Re: clear side repeaters fitted