Just Finished KL-ZE Mods

[Smokin mx-3]

well me and a buddy worked on my car all weekend and finally I'm done with my mods I put Brospeed headers, Clutch master Stage 3 and UR Flywheel the only problems that I had was I don't know if it was just me but the release bearing the flywheel came with did not fit so I had to find one, also the headers went in great the only problem I had was the gap left from the headers to the exhaust was to small to put my cat back in So i left it out it sounds amazing and I can't wait to let her go after the 500k break in on the clutch

[pelado]

I didn't know Brospeed made headers for an MX-3.

[jamik_69]

they dont they are for the probe