MX-3.com

hey, i'm Travis, moved to edmonton fron halifax last summer. i've been working very hard to get my car running and on the road for this summer. hope to meet some fellow mx-3ers here this summer

i have not had this car running on ms yet. the last time it ran was summer of 2008 after i did the engine build. then i tore it all apart, made the wires longer to run them through the frame and started to add all the goodies. i guess it might have been easier to put one peice on at a time and get e...

well, its been a long project, and i am down to the last bit before i fire the car up. i have a few questions on things i have been stuck on and have not been able to find specific answers to. the car have gone through a major electrical overhaul with ms2. 1) the ignition: i have msd 6a, blaster 3 a...

ok, thanks anyway, good luck with the sale

The g25m-r is a secound gen g-series tranny with a longer 5th gear and final drive. it should be stamped on the front towards the passenger side.

could you tell me whether it is a g25m-r or a g5m-r?

i know this is old, but do you still have any transmissions left?

have been doing alot of searching, but i havent found specific info that i need. i have a '96 and i need a wiring diagram for wiring in a msd 6a with ms, stock distributer without hei 4 pin. i have a hei but read you can not use it with ms because it does not put out the proper square sine wave. any...

crap, wrong section

wow!!! that is really nice. i just finished most of my wiring, but i think i may do it over to mimic this setup. very clean!!! i have a 96 but when i started wiring, i found that the 4th plug in my ecu can be totally eliminated if you have a wideband. the 4th plug is only for o2s and egr

i have been doing alot of searching, but i havent found specific info that i need. i have a '96 and i need a wiring diagram for wiring in a msd 6a with ms, stock distributer without hei 4 pin. i have a hei but read you can not use it with ms because it does not put out the proper square sine wave. a...

awesome, thats what i thought, but i just had to make sure. thanks man

just a question about installing a wideband o2. i welded a bung on my exhaust and installed the wideband there, but what do i do about the other o2 sensors? do i remove them and plug the holes, and if so, do i have to do anything with all the wiring for the removed o2 sensors?

just wanted to say hey, just moved to edmonton from halifax. i'm sure i'll see some of you around in the spring

thanks man