MX-3.com

Hrmm... this is just one of those things I cannot trust/figure out/believe unless I see/work with a real model. It seems like a very aquard attempt at a doubled up rotary engine. I cannot see that being a very reliable engine. The animations show how the inside 'pistons' should work, spinning around...

Har har. I'd love to split the bill with some roomies, but the Lease says max of two people (me and the girl) and no pets or anything. (Landlord had some bad tennants a while back).

Ummm, i've seen pics 1, 2, & 3 and they are pretty cool

but who the frig ripped off and half arsed the last ones. They are all just copys of the sun with color distortion.

I moved up to northern VT to get a good job. I don't have cable or anything yet.

I check forums and e-mail on my lunch break at work, no aim though

Life probably got busy once he got outa college...

I never got to meet him, but the both of us went to Vermont Tech... After I graduated I have had no time to work on the car or whatever (moving and working). Hopefully he'll come back! I did

Anyone ever had a 5 hour energy? http://www.5hourenergy.com/ I was crazy tired going into work one day, I usually have a couple balls, but a friend wanted to try the 5hr energy so I had one with... WOW! I was crusing! It kicks in after just a few short minutes and for me lasted close to 7 hours. Its...

Are you going to use any of that teflon stuff to patch/replace the hard lines? Is that safe?

I'd put my money on a bad bleed job, if they even did one... If you get on the breaks pretty hard does it fell like the pressure is inconcistant (stops hard fine one time but pulls left/right another)? Try double pressing the break, press it in and out rather quickly right before you break hard. Do ...

On the interstate today I had to slam on my brakes to avoid an accident, didn't lock 'em up. But wow! 60 to zero real quick. After I came to a stop you could see smoke from the drivers side rolling up over the fender. I couldnt tell if it was because they were wet (drizzling out) or if stopping that...

make sure you have a friend... some/most suspension stuff can be a pain to line things up and get bolts in/out. A friend makes things go a bit more smoothly. penetrating oil and a large breaker bar... I second that. When I first started doing the work on my car I had to go back to the autoparts stor...

Mine is starting to do the same thing... its not consistant though, very aggrivating when it happens though. Where on the peddle should the clutch start to enguage... as I let the peddle out the clutch doesnt start to grab till the peddle is almost all the way out, I don't remember it being this bad...

I just replaced a section of line on my other new car (95 talon tsi awd) and it was the line that runs to the rear passengerside. To replace that whole line I was too told that I would have to drop the whole subframe! Then I found out about replacing sectoins.... Go to you local Napa or whatever whe...

This reminds me of the Women = Evil proof:

women = time + money
>since time is money
women = money^2
>since money is the root of all evil
women = sqrt(evil)^2
>sqrt() to the power of 2 cancles
Women = Evil

15

was there a point to this post?

Bochek

My guess is so that he could post in the buy/sell, he was pretty busy postin yesterday

I've PM'd Mazda_Powered, but i've got a question for 2fazed just incase. The muffler and foot or so pipe that you've got, is it stock, or would it easly mate with stock piping? The pipe going to the muffler has a 7-8 inch rust hole in it, which I clamped a pipe over to hide :roll: Now i've got multi...