MX-3.com

Need one off the 1.6 DOHC 4 cyl engine (I believe they are different from the 6 to the 4, not sure if they are different or not between the two 4cyl engines). If you have one, let me know on here, or email me akamai69@gmail.com

Will take the headlights, email me akamai69@gmail.com

Do you have the headlights left? I need a drivers side headlight but will take both if you would rather sell them together.

No one has any suggestions?

It was after I found out the code that we were checking the vac lines.

P.S. This is a 94 mx-3, DOHC. Got quite a few kms on it (260k), 5 spd. If any of that helps.

So I've been trying to sell my mx3 recently. It's been sitting for awhile now, I've taken it for a quick spin every now and then, but it's been sitting for maybe a month. Never noticed any problems. I moved this past weekend, and yesterday, brought the mx3 to my new place (about 40mins away). Notice...

Ok, so everything is going good so far. However I have a quick question. The driveshaft (transaxle, whatever you want to call it) that goes from the tranny to the passenger side axle has a brace that bolts to the back of the engine. Sorry I didn't take a picture, but it's shaped as if there were thr...

The goal is most certainly not 650hp, lol. Never know what might happen 10 years down the road of course, I will never sell this car, so it may happen! But my main concern was will an N/A KLZE engine running with the above mentioned kit using 12:1 cr pistons run on the pump gas around here (91 octan...

Says on the site that they'll do 12:1 for special orders but don't keep them in stock anymore.

Yes, I understand that. But I mean is there anything else that would need to be done to handle the higher compression? I mentioned higher octane, but will pump gas here in canda be sufficent (I think 91 is the max we can get around where I am) to handle 12:1 pistons. I've heard people say before tha...

Well, the KLZE is not even in the car yet and I'm already thinking ahead for the possibilites. For my winter project I was considering either doing a turbo setup for it, or get the 650hp@9500rpm (or whatever it was) kit from cyborgzero, in PREPARATION for a turbo setup. Right now I'm leaning towards...

Whops, sorry.

I thought I had read all the FAQ sections. I also spent like 30 mins reading posts in this section on them. bah!

Oh well, thanks tho! Got what I'm looking for and more!

Hey, quick question... Like the topic says, does anyone have the part numbers for these handy?

Don't forget me, full kit.