MX-3.com

I have a 1992 Mazda Mx3 (4cyl, 1.6) with a 1994 Mazda 626 (V6, 2.5) engine in it. Yesterday my car was running fine. Today it was super cold (Michigan) and it wouldn't start. Hooked it up to my friends car to try and charge the battery and not die while trying to start it. But even when I finally g...

Wow, I have only had an experience like that one time, in a wrecker. I think I'd flip if I had an experience like that, or my gf either since she work on the car too. I too like advanced auto, haven't had any bad time there.

I have one bad shock and the rest are probably not far behind, anyone have any laying around?

Jeremy

A 2nd ++ from me!!

I just get mine on a day or two ago and I did as Sleeper6 and ground a bit off the throttle but I also cut I slight bit off the reservoir also. I might be able to fit a spacer in but I haven't taken time to check because I can't get them right now anyway, but I don't think it would fit.

I just finished putting my kl47 TB on my G4 manifold and as davmac said all I had to do is grind a little metal off the TB and IM where they meet. It only took me 10 mins with and angle grinder. I used the metal gasket that came with the TB and went together very easily. Also, if you need a kl47 TB ...

I installed the milli master. It is a bit of a pain tho. You reuse the old reservoir. You have to trim some of the housing from one of the sides to fit the mounting bolt. Take the banjo fittings off, bend the lines(carefully) to the other side of the master and screw the lines in directly. That's pr...

I'm with hotsiit near atown.

Any time. Personally, It's a bit much white for me and I'd probably go with the blue. I can definitely see where it would be a hard decision, both are very nice. Either way would be good to go and it is still a good looking car.

I like the hood and the 2 tone looks, Props to your ride.

NICE!!! I like all the rx's in there too!

I just made a DIY, I thought it was pretty easy, cutting the pipe being the hardest part...

If you have a v6 check your mid shaft axle bracket (that attaches to the back of the block), I had this same problem and found that my brackets bolts all loosened up and fell out on me, in fact, it did it again just recently. Thanks for reminding me I had forgetten.

Awesome sounds good! I, hopefully, should be there. I need to get inspected and an air filter.

Glad to hear, it sounded to be an interested endeavor.