MX-3.com

CEL = Check Engine Light, and I dont think you can have it scanned at autozone. But im not sure because I have never had anything that is odb2.

Havent had a chance to test the wires yet, will get around to it tommorow. But I had my exhaust fixed, had a leak at the cat and another leak where one of the hangers was welded on, And also went to a stock muffler. Seems to rev better and gained a tad bit of power back but doesnt feel as nice as my...

I hope you mean 180km/h, which is approx 110mph. In my sohc I touched 120mph at one point in time on a slight downslope. All stock with a fart can.

Plug the hole and adjust your idle, the idle air screw is on top of the throttle body youll need just a phillips screwdriver.

Im in the US, 93SOHC I sent you a Private Message.

First thing would be to fix the valve cover gasket, you can find a set on ebay for real cheap. And just do your basic tune up which consists of air filter, plugs, wires, distributor cap and rotor button. And it might not hurt to change the oil while your at it. Are you throwing any codes?

spray some carb cleaner around the areas where there are vacuum lines, the idle will raise when you find a leak as the the fluid will burn off when it gets sucked in.

Are you boosting the 1.6?

The tapping noise was most likely the lifters as they are noisy on these cars. Does the engine have good compression? What about the timing, make sure it is spot on.

First, test for 12v on the white/red wire. That wire is connected to the main relay. The other 3 wires run to the ECU. Test each for continuity to itself and to each other wire. Also test all 4 wires for continuity to ground. Each wire that you test should only show continuity to itself. If any wir...

I need a stock shift knob in decent shape, let me know what you got. Thanks.

Hi everyone, I am new to the board but I have been looking at threads on here for awhile now. I bought a 92 1.6 SOHC MX-3 as a new daily driver and I am having some problems with the gas mileage and the power band. I jumped TEN and GND and got only one code and that was code 3 which is crank angle s...