Search found 5 matches

by Graphixv2
January 6th, 2011, 2:47 pm
Forum: 4-Cyl. Technical/Performance
Topic: my car is possessed, intermitten stalls, dies and hesitates
Replies: 9
Views: 589

And the Winner IS:

wytbishop So far I would say the problem seems to be >> Massive Air leak. I previously fixed cracks in the main air hose (I thought) with silicon. The silicon doesn't seem to stand up to engine heat and the cracks were back. I wasn't even sure if they were all the way through the pipe but decided to...
by Graphixv2
January 5th, 2011, 12:46 pm
Forum: 4-Cyl. Technical/Performance
Topic: my car is possessed, intermitten stalls, dies and hesitates
Replies: 9
Views: 589

Re: my car is possessed, intermitten stalls, dies and hesita

Thanks for the replies. Yes, I did reset the ECU. Actually it's been reset multiple times for different things. Well, I'm going to go ahead and replace the temp sensor just because I already have a new one already. I'll keep that in mind about the distributor and test/and or replace. Whatever ends u...
by Graphixv2
January 2nd, 2011, 4:50 pm
Forum: 4-Cyl. Technical/Performance
Topic: my car is possessed, intermitten stalls, dies and hesitates
Replies: 9
Views: 589

my car is possessed, intermitten stalls, dies and hesitates

This car will intermittenly just die when you let off the gas. When you immediately restart the car, it runs fine until the next time it decides to do it. Sometimes the RPM will dip down to zero like it's dying, only to jump back up. Intermittenly the car will completely lose power between 2000-3000...
by Graphixv2
May 16th, 2008, 11:23 pm
Forum: Electrical & Lighting
Topic: Interior Blower fan only works in high position
Replies: 3
Views: 208

Re: Interior Blower fan only works in high position

Thanks, found it.

Bad soldier connection on the ceramic resistor.
Well, least it doesn't have to be replaced.
by Graphixv2
May 16th, 2008, 1:41 pm
Forum: Electrical & Lighting
Topic: Interior Blower fan only works in high position
Replies: 3
Views: 208

Interior Blower fan only works in high position

1993 MX-3 The vent fan only comes on in position "4" I have checked the voltage to the fan and the voltage readout confirms that the blower is getting around 12-13 volts in "4" but next to nothing in any other position (like 3 volts in any other). If you turn on the AC, the light...

Go to advanced search