MX-3.com

TPS sensor might be bad?

remove the cover on the brake light, take the 3 plugs off the rear plastic trim, remove the 2 front side plastic trim pieces, remove the 3rd brake light, remove the 6 nuts holding the cover on the outside, reverse to install.

mine just lost its trans(

I agree, sound like it.

put a mechanical one on and read the pressure, the lights are pretty useless, you can fry your motor if the pressure is low.

When I did my frt brakes I notice some play in the swaybar link, not sure how much play is normal, should it be tight or a little sloppy? Thanks.

Fixed, FYI it is a shoulder bolt (16mm hex) on the bottom, replacement parts are about $50, but festuva compressors have the same thread size, but they are a little longer. Looks like once the valve blows they are done. A/C is fixed)

bad gas? how much is in it?

Well I found my leak, it leaking from the relief valve on the compressor, any one know how to reset, replace, fix it? Anyone got a picture of the valve, its on the bottom of the compressor, thanks.

they're like $60 from autozone new, why go thru all the work and put in an used one?

hers what i did, after you check the pressure: 1. check to make sure the compressor is working, put 12v to the wire off the compressor and when the engine is running, see if the clutch engages, if it engages the compressor and clutch work. 2. make sure the fuse is good in the eng compartment and tur...

I figuered it out, the holder must be on the radio surround but was broke/missing, so I tie strapped the socket to the lighter and now it lights the surround, thanks.

The hole is part of the dash? There are 2 large holes only on mine.

I just replaced the radio surround and there is a plastic piece to light the area around the lighter, the bulb is on the wiring to the lighter, but I can't seem to see where the bulb fits, is it in the ashtray area? Thanks.

Let me know how it goes, my 93's arent working either and I planned on taking it in after I finish some other stuff