MX-3.com

Hi all, So I am currently getting all the bits together so I can turbo my ZE. I have an external wastegate, this fits onto a pre made spur on the headers just before the turbo, the problem I have is there is no return pipe/connector on the downpipe. What did others do? I don't want a screamer pipe s...

Hi all,

I am about to relocate my battery to the boot and will be buying an optima yellow top but which one?

Which one do other have?

Thanks in advance

Jon

Hi, I have a problem with my KL-ZE.. It has recently developed quite a bad missfire from a cold start, once the engine gets up to temperature the missfire seems to go away! The car also trys to stall when I stop, the revs drop and will either go back to normal or will actually stall. I have changed ...

On another note...

So far I have started the ZE on the K8 ECU, and it starts fine.

Last night I decided to put in the KL-31 ECU I got with the ZE, so with that plugged in I turned the key and..... nothing! The car turns over but thats it, does it look like I have a bad ECU?

Thanks

Jon

Thanks pat,

I will bend the stock bracket then and make my own bracket at a later date.

Time to go home and have some fun

Thanks again

Jon

Hi guys, I have a small problem with my ZE swap! All has gone fine, but the only thing is the stock accerator cable is way to slack to the TB, I have set it as far back as possible but there is still some slack!! I have been told to bend the bracket back, but am a little worried about doing this.. H...

Turbo pipe Kit

As fitted to Nitrous Fusion's MX-3 i believe

http://www.jeroentje.nl/index.php?page= ... 2&car_id=4

Jono

K, I checked again yesterday,

Wired TEN - GND & LED on FEN - B+

The LED came on for a few seconds then went off and stayed off! I assume this means there are no codes?

Jon

I cleared the codes, went for a drive, then tryed the TEN - GND while the car was off!

Jon

Yeah I tryed that too and the light stayed on!

I also did the remove Neg from batt, then press brake for 20 secs!

But only did the test I said above, I will try again tomorrow!

Thanks

Jon

Hi, I am trying to pull codes (if I have any) from my UK 92 1.8 V6 MX-3, I am putting a LED between GND & TEN, When i switch ignition to ON, The LED comes on and the VRIS valves click open and closed, so it looks like it is testing, however the LED just stays on! Does this mean all is ok? or is ...

Thanks Guys,

Sorry, Its a 94 MX (UK), I would go down the DE route but it seems a very hard motor to find here in the UK, also im only plannin to run around 5-6 PSI if I get around to boosting it

I will check out the brake/suspension forums again

Jon

Just a few quick questions, I am going to get my ZE motor on saturday, along with a xedos 9 IM, TB & ECU Is there anything else I should be gettin at the same time? I am planning to turbo the ZE early next year and have been told that the ZE will take up to 8PSI Stock, however is there anything ...

Yeah I am likin the look of the mazdaspeed one!

Im still big on the sleeper look so I think that it will be good

Thanks

Jon

Hey Guys.... Some idiot hit my front bumper yesterday: http://i62.photobucket.com/albums/h88/uk_mx3_guy/DSC00408.jpg So im now lookin for a modded front bumper, I dont want it to be massivly different from the orginal! I like the orignal design... I want to be able to put an Intercooler in there at ...