MX-3.com
http://mx-3.com/phpBB3/

Eunos 800 KL62 PCM (ECU) (ECM)
http://mx-3.com/phpBB3/viewtopic.php?f=9&t=72602
Page 1 of 1

Author:  JM1EC-V6 [ January 15 2010, 8:11 PM ]
Post subject:  Eunos 800 KL62 PCM (ECU) (ECM)

Hi, I am from Canada and doing a important engine conversion with a JDM Eunos 800 KL-ZE engine (TA5Z Chassis).

Just NEED A GOOD PERSON to find the ECU pinout and I.A.T. / M.A.F. wiring to run the motor.

Ecu P/N: KL62 18 881A

Vehicle: 1994 JDM Eunos 800 (1 ECT Sensor)

Engine: 2.5L DOHC KL-ZE 10:1 CR

Thanks !

Author:  fowljesse [ January 15 2010, 11:06 PM ]
Post subject:  Re: Eunos 800 KL62 PCM (ECU) (ECM)

I wish you luck. Those are hard to find. However, the K8 isn't too far off, and you can run the JE50 MAF. You can have most K8 ECUs reflashed.

Author:  Nd4SpdSe [ January 23 2010, 12:58 PM ]
Post subject:  Re: Eunos 800 KL62 PCM (ECU) (ECM)

Here's just the 95 Millenia 2.5 wiring. Not sure if it'll help

Image
Image

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/